t_sndrel

- initiate an orderly release

Synopsis

#include <xti.h>

int t_sndrel(int fd);

Description

This routine is part of the XTI interfaces which evolved from the TLI interfaces. XTI represents the future evolution of these interfaces. However, TLI interfaces are supported for compatibility. When using a TLI routine that has the same name as an XTI routine, the tiuser.h header file must be used. Refer to the TLI COMPATIBILITY section for a description of differences between the two interfaces.

For transport providers of type T_COTS_ORD, this function is used to initiate an orderly release of the outgoing direction of data transfer and indicates to the transport provider that the transport user has no more data to send. The argument fd identifies the local transport endpoint where the connection exists. After calling t_sndrel(), the user may not send any more data over the connection. However, a user may continue to receive data if an orderly release indication has not been received. For transport providers of types other than T_COTS_ORD, this function fails with error TNOTSUPPORT.

Return Values

Upon successful completion, a value of 0 is returned. Otherwise, a value of –1 is returned and t_errno is set to indicate an error.

VALID STATES

T_DATAXFER, T_INREL.

Errors

On failure, t_errno is set to one of the following:

TBADF

The specified file descriptor does not refer to a transport endpoint.

TFLOW

O_NONBLOCK was set, but the flow control mechanism prevented the transport provider from accepting the function at this time.

TLOOK

An asynchronous event has occurred on this transport endpoint and requires immediate attention.

TNOTSUPPORT

This function is not supported by the underlying transport provider.

TOUTSTATE

The communications endpoint referenced by fd is not in one of the states in which a call to this function is valid.

TPROTO

This error indicates that a communication problem has been detected between XTI and the transport provider for which there is no other suitable XTI error (t_errno).

TSYSERR

A system error has occurred during execution of this function.

TLI COMPATIBILITY

The XTI and TLI interface definitions have common names but use different header files. This, and other semantic differences between the two interfaces are described in the subsections below.

Interface Header

The XTI interfaces use the header file, xti.h. TLI interfaces should not use this header. They should use the header:

Error Description Values

The t_errno values that can be set by the XTI interface and cannot be set by the TLI interface are:

Notes

Whenever this function fails with t_error set to TFLOW, O_NONBLOCK must have been set.

Attributes

See attributes(5) for descriptions of the following attributes:

See Also

t_error(3NSL), t_getinfo(3NSL), t_open(3NSL), t_rcvrel(3NSL), attributes(5)