myri10ge

- Myricom Myri10GE 10Gb PCI Express NIC Driver

Synopsis

/dev/myri10ge*

Description

The myri10ge Gigabit Ethernet driver is a multi-threaded, loadable, clonable, GLD-based STREAMS driver that supports the Data Link Provider Interface, dlpi(7P), on Myricom Myri10GE 10-Gigabit Ethernet controllers.

The myri10ge driver functions include controller initialization, frame transmit and receive, promiscuous and multicast support, multiple transmit and receive queues, support for TCP Large Send Offload, support for TCP Large Receive Offload, and error recovery and reporting.

Application Programming Interface

The cloning character-special device, /dev/myri10ge, is used to access all Myricom Myri10GE 10 -Gigabit Ethernet dev ices installed within the system.

The myri10ge driver is managed by the dladm(1M) command line utility. dladm allows VLANs to be defined on top of myri10ge instances and for myri10ge instances to be aggregated. See dladm(1M) for more details.

You must send an explicit DL_ATTACH_REQ message to associate the opened stream with a particular device (PPA). The PPA ID is interpreted as an unsigned integer data type and indicates the corresponding device instance (unit) number. The driver returns an error (DL_ERROR_ACK) if the PPA field value does not correspond to a valid device instance number for the system. The device is initialized on first attach and de-initialized (stopped) at last detach.

The values returned by the driver in the DL_INFO_ACK primitive in response to your DL_INFO_REQ are:

• Maximum SDU is 9000.

• Minimum SDU is 0.

• DLSAP address length is 8.

• MAC type is DL_ETHER.

• SAP (Service Access Point) length value is -2, meaning the physical address component is followed immediately by a 2-byte SAP component within the DLSAP address.

• Broadcast address value is the Ethernet/IEEE broad- cast address (FF:FF:FF:FF:FF:FF).

• Once in the DL_ATTACHED state, you must send a DL_BIND_REQ to associate a particular SAP with the stream.

Configuration

Link speed and mode can only be 10000 Mbps full-duplex. See the IEEE 802.3 Standard for more information.

Files

/dev/myri10ge*

Special character device.

/kernel/drv/amd64/myri10ge

64-bit device driver (x86)

/kernel/drv/sparcv9/myri10ge

64-bit device driver (SPARC)

/kernel/drv/myri10ge.conf

Configuration file

Attributes

See attributes(5) for a description of the following attributes:

See Also

dladm(1M), netstat(1M), driver.conf(4), attributes(5), dlpi(7P), streamio(7I)

Writing Device Drivers

Network Interface Guide

STREAMS Programming Guide

IEEE 802.3 Standard